Regency 4734 Instrukcja Instalacji Pobierz pdf (Strona 21)

Regency

Model 4734 Access Control Expander Installation Manual (P/N 150807, Rev. A) Revised 5/98

4.5.2 Display Macros

There are several “macro” message characters that activate special displays and may be embedded within

any message. Be aware that the displays take a certain number of characters each.

When using the 5540, the macro characters are preceded with a \ (backwards slash) character. In the built-in

programmer, macro characters are preceded by the character ¥. To enter this character, press 2 8 on the

touchpad.

EXAMPLE: To display ARMED with the armed areas on line one of the LCD, enter ARMED:\A for

System Message #57. To display DATE with the current date on Line 2, enter DATE:\D for System

Message #58.

As you are programming, you will see the shortened form of the message. During normal use, the actual,

non-abbreviated message will appear.

4.6 Programming Secret Codes or Cards

This menu is useful if you only want to change secret codes without going through all the options in the

CARDS/CODES Menu (Menu 1). See Section 5.2 of this manual for more information. To access the

SECRET CODES Menu, press 7 TEST then enter Code 0 or Code 1, other codes may be used, but they

must have PROGRAM selected in their user profile and they will only program codes with higher ID’s.

4.6.1 Loading Cards

After 7 TEST is entered, the prompt “BULK LOAD?-YES/NO” appears. Select yes if you will be loading

access cards which will all be using the same user profile. For loading cards by swiping, the card reader must

be connected to the same touchpad that Program Mode is activated from. Alternatively, the 4420 Card Inter-

face can temporarily be set to the same station ID as the touchpad where Program Mode was activated.

After selecting BULK LOAD, select the first code ID slot to program at the “CODE#:0” prompt. Codes will

be programmed into successive ID slots. At the “PROFILE#0:0” prompt, select the profile number that will

be used for the card block being loaded. All cards will be assigned to the same profile as entered here. After

pressing TEST, begin presenting cards to the card reader, until all cards are programmed. After the last card,

press MUTE MUTE to exit Program Mode.

4.6.2 Loading Individual Secret Codes Or Cards

If BULK LOAD mode is not selected, each code entered will also require the user PROFILE to be entered.

Each code may be assigned a different profile.

Table 5: Macro/Function

Macro Function Display Width

\T TIME DAY HH:MM AM 9 + day field

\M 24HR TIME DAY HH:MM 6 + day field

\D DATE MM/DD/YY 8

\E DATE (European format) DD/MM/YY 8

\A ARMED AREAS 12345678 8

\R READY/NOT READY READY, NOT READY, READY 12345678 (N/A)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 69 70

Brak uwag

Regency 4734 Instrukcja Instalacji Strona 21